Having trouble with your Twister? Check this list to see if there is an answer already posted.
Twister Troubleshooting
Pump Does Not Pump Water• Make sure that the water level in the reservoir is near the top. The more water that is in the reservoir, the less the pump has to work.• Turn the grinder on, off, and then back on. This will frequently make the pump work.• Use a small plastic bottle or some similar device to suck water into the outlet tube. With the water reservoir full, attach your suction device to the outlet end of the tube. It is very important to remove all of the bubbles from the line, so continue sucking the water through the tube until you are sure that there are no more air bubbles remaining.• Make sure pump is properly aligned. Refer to instructions and photo on this page.Water leaks out of bottom of grinder• Make sure that water hose is not pointed towards the motor shaft.Loud Noise when grinder on• A loud noise when in use could signal a damaged motor bearing. To prevent this damage, make sure that water hose does not spray water into motor area.Cannot attach Grinding Pin to shaft when second story in place• Usually you will have to lower the standard bit in order to make room for the second bit or pin. To lower the standard Slip-On bit, remove the 1" bit and adaptor, then use the Allen Wrench provided to loosen the set screw in the 3/4" Slip-On bit adaptor and lower the adaptor to the desired position.
|